mx5cartalk.com

Posted: **Tue Sep 09, 2014 2:28 pm**

Correctly installed front/rear - not reversed?

Old suspension may have sagged so difference might not be as noticeable.

What are the new height measurements at the seam welds?

Posted: **Tue Sep 09, 2014 2:30 pm**

Also...did you tighten everything back up under load or in the air?

Posted: **Wed Sep 10, 2014 4:00 pm**

Make sure you loosen things off a bit before re-tightening it all with the car on the ground.

Posted: **Wed Sep 10, 2014 6:12 pm**

KevGoat wrote:Old suspension may have sagged so difference might not be as noticeable.

^this^

mx5cartalk.com

Lowering springs no lower?

Re: Lowering springs no lower?

Re: Lowering springs no lower?

Re: Lowering springs no lower?

Re: Lowering springs no lower?