Breather hose to Intake brainstorm.

[narita]

Afternoon gents,

Check it, i am trying to work out a way to run the breather hose into the intake pipe.

i would rather not have anything that could come loose in the intake. Such as washers or nuts.

here is the intake.



i am considering using a plastic 15mm male union with silicone for extra air tightness.

any suggestions welcome

[Nevyn72]

Looking at that image you've got your MAF installed the wrong way around......

[emily_mx5]

Looking at that image you've got your MAF installed the wrong way around......

OMG I am laughing hahahaa, it won't fit the correct way either with that 2.5" silicone 90* hose as it's 2.75" diameter.
Lol nice intake derpppp.

To answer your question, This.

[narita]

I will forgive the derp. Because you posted that amazing product. Where can i pick one up?

[narita]

NARITA : 23

CARTALK : 1

[fastfreddygassit]

As to where you can get these from..
clicky here for EBAY
But you are looking at 2 weeks and at least $40 (the cheapest is from the tougefactory) for what is basically a barb fitting.

or PM simon/lokiel or billybunter and see if they have any left
http://mx5cartalk.com/forum/viewtopic.php?f=57&t=41091&start=89

Maybe take the pic emily_mx5 supplied and got to your local industrial hose joint and see if they have suggestions/alternatives.


and because I couldn't resist...

NARITA : 23

CARTALK : 1

In accepting this award, I would like to thank the Academy, God, and my FB friends at F#CK JDMST!


good luck

[narita]

Thanks freddy.

this is not my brightest moment.

The speech was lovely.

[Snowmotion]

Anyone else in Sydney want one of these fittings? Found this ebay listing with reasonable freight per additional piece.
http://www.ebay.com.au/itm/380190716997?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
I will split the freight with anyone else who wants one.

[narita]

ok I used some fitting from work with a 16mm holesaw.

this was a VERY CHEAP option.