mx5cartalk.com

Afternoon gents,

Check it, i am trying to work out a way to run the breather hose into the intake pipe.

i would rather not have anything that could come loose in the intake. Such as washers or nuts.

here is the intake.



i am considering using a plastic 15mm male union with silicone for extra air tightness.

any suggestions welcome

Looking at that image you've got your MAF installed the wrong way around......

Nevyn72 wrote:Looking at that image you've got your MAF installed the wrong way around......

OMG I am laughing hahahaa, it won't fit the correct way either with that 2.5" silicone 90* hose as it's 2.75" diameter.
Lol nice intake derpppp.

To answer your question, This.

I will forgive the derp. Because you posted that amazing product. Where can i pick one up?

NARITA : 23

CARTALK : 1

As to where you can get these from..
clicky here for EBAY
But you are looking at 2 weeks and at least $40 (the cheapest is from the tougefactory) for what is basically a barb fitting.

or PM simon/lokiel or billybunter and see if they have any left
http://mx5cartalk.com/forum/viewtopic.php?f=57&t=41091&start=89

Maybe take the pic emily_mx5 supplied and got to your local industrial hose joint and see if they have suggestions/alternatives.


and because I couldn't resist...

narita wrote:NARITA : 23

CARTALK : 1

In accepting this award, I would like to thank the Academy, God, and my FB friends at F#CK JDMST!


good luck

Thanks freddy.

this is not my brightest moment.

The speech was lovely.

Anyone else in Sydney want one of these fittings? Found this ebay listing with reasonable freight per additional piece.
http://www.ebay.com.au/itm/380190716997?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
I will split the freight with anyone else who wants one.

ok I used some fitting from work with a 16mm holesaw.

this was a VERY CHEAP option.