Correctly installed front/rear - not reversed?
Old suspension may have sagged so difference might not be as noticeable.
What are the new height measurements at the seam welds?
Lowering springs no lower?
Moderators: timk, Stu, -alex, miata, zombie, Andrew
-
KevGoat
- Speed Racer
- Posts: 3968
- Joined: Sun Jun 17, 2012 8:48 pm
- Vehicle: NB SE
- Location: Down South, Adelaide, SA
-
KevGoat
- Speed Racer
- Posts: 3968
- Joined: Sun Jun 17, 2012 8:48 pm
- Vehicle: NB SE
- Location: Down South, Adelaide, SA
Re: Lowering springs no lower?
Also...did you tighten everything back up under load or in the air?
-
JBT
- Speed Racer
- Posts: 7946
- Joined: Tue Jun 03, 2003 11:00 am
- Vehicle: NC
- Location: Brisbane
Re: Lowering springs no lower?
Make sure you loosen things off a bit before re-tightening it all with the car on the ground.
-
project.r.racing
- Speed Racer
- Posts: 3722
- Joined: Sun Jan 18, 2009 10:16 pm
- Vehicle: Non MX-5
- Location: Glasshouse Mountains, QLD
Re: Lowering springs no lower?
^this^KevGoat wrote:Old suspension may have sagged so difference might not be as noticeable.
Return to “MX5 Wheels, Suspension, Brakes & Tyres”
Who is online
Users browsing this forum: No registered users and 16 guests
